Run smart contract function

$run smart contract function is a function in UBot Studio that allows you to execute a function on a specific smart contract on a specified blockchain chain.

Parameters

Chain: The blockchain on which the smart contract resides.

Contract Address: The address of the smart contract that contains the function you want to execute.

Function Name: The name of the function you want to run on the smart contract.

Parameters: The parameters for the function, if any. They should be written as a comma-separated list within quotes.

Return Value

This function returns the result of the function executed. The type of this result depends on what function is executed on the smart contract.

Example

config defi wallet("your private key")
log("Smart Contract Function Result: {$run smart contract function("BinanceSmartChain", "0x1234abcd5678efgh9012ijkl34mn56op7890qrstu", "balanceOf", '"0xabcdef123456ghijklm789012nopqr3456stuvwx89"')}")

Please replace "your private key" with your actual DeFi wallet's private key.

Be mindful when you are handling your private key. It's a sensitive piece of data that allows full control over your funds in your DeFi wallet. Therefore, never share this key publicly or with anyone.

The above example gets the "balanceOf" function result for the specified wallet address on a specific smart contract in the Binance Smart Chain.

Before executing a function on a smart contract, make sure to check if it will alter the state of the smart contract or if it only reads data. Reading data is usually free, but altering state might cost gas.